Clear-com Eclipse-PiCo User Manual Page 23
- Page / 79
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Clear-Com Communication Systems
Eclipse PiCo Matrix Instruction Manual
2-7
CONNECTING TO GENERAL-PURPOSE INPUTS
The female 25-pin D-type socket labeled “GP IN” allows the Eclipse
PiCo matrix to be connected to eight general purpose inputs (GPIs).
An external logic device–such as an external foot switch, a
panel-mounted switch, or the logic output of some other device– can
be connected to the “GP IN” connector. When the external logic device
is activated, it sends a control signal into the matrix to perform one of
several preset functions, such as turning an intercom panel’s
microphone on or off, muting a microphone’s output, or turning a
panel’s speaker off. The function to perform, and the panel upon which
it is performed is programmed from the Eclipse Configuration System
software.
Note: A shielded cable should be used.
CONNECTING TO A GPI/RLY INTERFACE
The RJ-45 socket labeled “GPI/RLY Interface” connects the Eclipse
PiCo matrix to a GPI-6 or RLY-6 card. The GPI-6 provides six
general-purpose opto-isolated logic inputs. The RLY-6 card provides
six single-pole, double-throw relay outputs.
Both card types mount in either an IMF-3 interface frame or an
IMF-102 interface frame. Up to ten GPI-6 or RLY-6 cards can be
operated at one time from the matrix by daisy-chaining the cards
together. Each card has an IN and an OUT connector for this purpose.
The RLY-6 and GPI-6 cards connect to the GPI/RLY interface
connector using shielded category-5 cable. For more information about
the GPI-6 and RLY-6 cards, consult their respective manuals.
Note: If this port is used a ferrite must be added to the socket end
of the cable. A suitable ferrite is Würth Electronik part:
74271132.
Note: A shielded cable should be used.
CONNECTING TO A SECOND ECLIPSE PICO
MATRIX
Shielded category-5 (CAT-5) cable is connected from the “base loop”
socket of one Eclipse PiCo matrix to the “base loop” socket of a
second Eclipse PiCo matrix to form one non-blocking 64-port Eclipse
matrix system. The cable connecting the two matrices can be up to 1
meter (3.28 feet) long.
The link is activated from the “My Systems” screen in the Eclipse
Configuration System.
4
5
6
- ECLIPSE PICO MATRIX 1
- INSTRUCTION MANUAL 1
- Part Number 810348Z Rev. 5 2
- CONTENTS 3
- IMPORTANT SAFETY INSTRUCTIONS 7
- Figure ii-1: Safety Symbols 8
- INTRODUCTION 9
- INTELLIGENT LINKING 10
- HIGH SPEED LINK 10
- POWERFUL PROGRAMMING FEATURES 11
- INDIVIDUAL LEVEL CONTROL 12
- EXCELLENT AUDIO QUALITY 12
- ROBUST AND COMPATIBLE 12
- SYSTEM BASICS 13
- REMOTE INTERFACES 16
- OPERATING AN 17
- ECLIPSE PICO 17
- PC CONNECTOR 18
- RESET BUTTON 18
- OK LIGHT 18
- CONFIGURATION “CONFIG” BUTTON 18
- CONFIGURATION STATUS LIGHTS 19
- LAN STATUS LIGHTS 19
- DISPLAY WINDOW 19
- SETUP/ENTER KNOB 20
- DEFAULT IP ADDRESS 20
- CONNECTING TO AC POWER 21
- MATRIX 23
- USING THE PICO 25
- FRONT PANEL 25
- MENUS 25
- CHECKING PORT STATUS 26
- ADJUSTING AUDIO LEVELS 27
- CREATING AUDIO ROUTES 29
- ACCESSING SYSTEM INFORMATION 33
- ACCESSING SYSTEM STATUS 33
- System Status 34
- High Speed Link 34
- Local Area Network 34
- RESETTING THE SYSTEM 36
- POSE INPUTS (GPIS) 37
- POSE OUTPUTS (GPOS) 37
- INSTALLING AN ECLIPSE 39
- PICO MATRIX 39
- BATTERY BACKUP 40
- WIRING TO AC MAINS POWER 41
- WIRING TO 4-WIRE EQUIPMENT 42
- Single-Pair Digital 43
- WIRING GENERAL-PURPOSE INPUTS 45
- Non-Isolated Mode 46
- Opto-Isolated Mode 46
- RLY-6 Interface Wiring 48
- To Matrix 49
- Rear View of IMF-3 Frame 50
- Interface 50
- Connector 50
- GPI-6 Interface Wiring 51
- To External Device 52
- Configuration 53
- WIRING TO A COMPUTER 55
- MAINTAINING AN 57
- SPECIFICATIONS 59
- System Programming 60
- Minimum PC Requirements 60
- Recommended PC Requirements 60
- Power Supply Unit 61
- Notice About Specifications 61
- APPENDIX: PICO 63
- MENU MAP 63
- Vitec Group Communications 64
- GLOSSARY 65
- Eclipse Glossary 66
- ECLIPSE MANUALS 69
- Eclipse Manuals 70
- LIMITED WARRANTY 71
- Standard Limited Warranty 72
- NOVEMBER 1, 2008 75
- REPAIR POLICY 78
Related products and manuals for Accessories communication Clear-com Eclipse-PiCo
(86 pages)
(83 pages)© 2020, manymanuals.com. All rights reserved. | 0.687 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals