Clear-com Eclipse-PiCo User Manual download pdf (Page 21)

Clear-Com Communication Systems

Eclipse PiCo Matrix Instruction Manual

2-5

CONNECTING THE MATRIX TO REMOTE

DEVICES

The Eclipse PiCo matrix connects to remote devices such as intercom

panels, interfaces, general purpose inputs and outputs, and other

matrices through its rear-panel hardware connectors.

The following sections describe the rear-panel connectors. The

Installation Chapter of this manual gives pin assignments for each

connector.

Figure 2-3: Rear Panel of an Eclipse PiCo Matrix

CONNECTING TO AC POWER

An Eclipse PiCo matrix’s rear panel contains two IEC AC power input

sockets for connecting AC mains power to the two power supplies.

Each IEC socket connects cable to one power supply, operating at an

input voltage of 100 to 240 volts, between 50 and 60 hertz.

CONNECTING TO PANELS AND INTERFACES

An Eclipse PiCo matrix’s rear panel contains 36 RJ-45 sockets for

connecting the matrix to remote intercom panels and interfaces. These

sockets are often called “ports”. Each port socket is given a number on

the rear-panel for easy identification.

All ports contain a voice detection mechanism (“VOX”) that is

programmed from the Eclipse Configuration System software. VOX

1 Two IEC AC power input connectors,

(1 per power-supply unit )

2 RJ-45 port connectors (36)

3 General purpose outputs connector

(male, 25-pin, D-type)

4 General purpose inputs connector

(female, 25-pin, D-type)

5 GPI/RLY interface connector (RJ-45)

6 Base loop connector (RJ-45)

7 LAN connector (RJ-45)

Note: General Purpose

Outputs are also referred to

as “relays.”

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 78 79

No comments

Clear-com Eclipse-PiCo User Manual Page 21