Clear-Com Tempest 900 Specifications download pdf (Page 47)

41 Tempest®900 4-Channel Wireless Intercom System

Charging the Lithium-Polymer Baery

With the Lithium-Polymer baeries installed in the baery compartment, plug the AC

end of the supplied 5VDC Charger/Power Supply into a standard AC wall outlet. Open

the rubberized access cover on the side of the BeltStaon and plug the USB end of the

Charger/Power Supply into the USB connector. The Lithium-Polymer baeries will take

approximately 2¾ hours to charge from completely empty to completely full. This me is

the same with the BeltStaon turned ON or OFF. A new, fully charged baery should power

a Tempest BeltStaon for approximately nine hours.

Fast charging with the supplied fast charger requires a temperature range of 32° – 113° F.

Baeries can receive more than 500 charge cycles, and connue to maintain more than

70% of their power rang. The Tempest baery indicator will maintain its accuracy as

baery life decreases.

Alternavely, remove the Lithium-Polymer rechargeable baery from the BeltStaon

and insert it into the oponal 5-Bay Baery Charger. The Lithium-Polymer baeries

will take approximately 2½ hours to charge from completely empty to completely full.

See the baery charger manual for addional details.

Power Opons

The Tempest BeltStaon can be powered by:

» Supplied Lithium-Polymer baery.

» AA baeries; it is safe to connect a power supply to a BeltStaon with AA baeries installed. It will not harm the

BeltStaon, but will not charge the AA baeries either.

» Supplied baery charger / power supply.

BeltStaon Power ON/OFF

• The Power ON/OFF buon is used to turn the BeltStaon ON or

OFF.

• Press and hold the Power ON/OFF buon for two seconds to turn

the BeltStaon ON.

• Press and hold for four seconds to turn the BeltStaon OFF.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 101 102

No comments

Clear-Com Tempest 900 Specifications Page 47