Clear-Com HME DX210 Operations Instructions download pdf (Page 30)

 Repeat these steps for each remaining secondary base station. Use a different number for each.

Only the primary base station and the secondary base station you are currently working with should

have power on during registration. All other equipment should be off.

 After all secondary base stations are registered and COMMUNICATOR

s are registered, power up

all base stations. Press reset on the primary base station and let it recover. Turn on the primary

Communicators and let them link. Press the reset on each secondary base station one at a time and

let it link to the primary, as indicated by a single bar. Turn on the Communicators associated with the

secondary base stations. Do one group at a time until they have all linked. Then do the next group.

At this point all base stations and Communicators should be powered up and linked, ready for use.

 Now proceed with normal system configuration, setting functions and levels as required.

 If it becomes necessary to replace a secondary base station, use the procedure above to register the

new secondary with the same number as the old secondary. After registration, you will have to

 If it becomes necessary to replace a primary base station, follow the above procedure completel

Before registration of the secondary base stations, clear the previous secondary registration as

follows. For each secondary, press the

primary

have to be registered again.



ut down after

recognize

on, with the primary

base station remaining active and the secondary base station displaying one bar.

CLR/BND button and the RESET button at the same time.

Continue holding the

CLR/BND button after you release the RESET button, until the clear code “c”

(lower case) appears on the

STATUS display. Any Communicators associated with the old

will have to be registered to the new primary after secondary base station registration. All

Communicators associated with secondary base stations also

If the primary base station is shut down or if the primary base

is powered off for more than 30 seconds, all secondary base

stations will drop their Communicator connections and begi

searching for the primary. If the primary is not found in 30

seconds, the secondary will automatically revert to primary-

mode operation and reconnect the Communicators. At this

point the secondary STATUS displays will show three bars.

If the primary is turned back on it will be necessary to press

RESET on all secondary base stations to allow them to find

and initialize to the primary again. It is therefore important t

have all base stations connected to the same AC circuit to

prevent this situation when the system is sh

Three bars

Secondary base station

operating in primary mode

when no primary base station

is found

hours and powered up again the next day.

NOTE: You cannot register Communicators to a base that is set to primary mode, and then switch the

base mode to secondary for registration. Once in secondary mode, the base station cannot

the Communicators registered during primary operation. For secondary base stations, the

Communicators must always be registered after secondary base station registrati

Clear-Com HME DX210 System Guide

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Clear-Com HME DX210 Operations Instructions Page 30

Comments to this Manuals

Related products and manuals for Door intercom systems Clear-Com HME DX210