Clear-Com HME DX210 Operations Instructions download pdf (Page 15)

If you try to register more than 15 Communicators:

 An F will appear on the STATUS display on the base station and you will hear “Registration failed” in

the headset.

 Clear all current registrations by pressing the CLR/BND button and the RESET button at the same

time. To press the RESET button, insert a pen or similar pointed object into the RESET hole at the

lower-left corner of the base station front panel. Continue holding the CLR/BND button after you

release the RESET button, until the clear code “c” (lower case) appears on the STATUS display.

 Register all active Communicators, one at a time. Previously registered Communicators must be

re-registered.

2.3.3 COMMUNICATOR

Settings

If you want to set up a Communicator with any of the special settings shown below, press and hold the

specified button combinations during or after power up. These settings will remain in memory when the

Communicators are turned off and on again.

For Setting Press & Hold while you Press & Release the Power button

ISO restrict on

IC1 button

ISO restrict off

IC1 ISO and buttons

Handsfree on selected button(s)

IC1 and/or IC2 ISO and and/or  volume up buttons

Handsfree off selected button(s)

IC1 and/or IC2 and/or ISO and  volume down buttons

Listen-Only mode on  volume down button

Listen-Only mode off  volume up button

WH210 only *

All-In-One Headset “lights-off” mode

IC2 button

* NOTE: All-In-One Headsets can be set up with its indicator lights off, to avoid distraction if users are in an area

visible to audience. This setting is not saved when you power off.

For Setting With the power already on - - -

Increase mic gain (15 steps)

Press IC2 while you repeatedly press the  volume up button

Decrease mic gain (15 steps)

Press IC2 while you repeatedly press the  volume down button

BP210 only *

Increase sidetone level (5 steps)

Press IC1 while you repeatedly press the  volume up button

BP210 only *

Decrease sidetone level (5 steps)

Press IC1 while you repeatedly press the  volume down button

* NOTE: There is no sidetone adjustment function for All-In-One Headsets.

Power

button

NOTE: If you are not connecting a wired intercom, go on to

System Operation, section 3, page 13.

Clear-Com HME DX210 System Guide

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comments to this Manuals

No comments

Clear-Com HME DX210 Operations Instructions Page 15

Comments to this Manuals

Related products and manuals for Door intercom systems Clear-Com HME DX210