Clear-Com HME DX210 Dual-Channel Wireless Intercom Operating Instructions HME# 400G661Rev B 6/2/11
2 System Setup This chapter describes how to set up and configure the DX210. Typical equipment connections to the rear panel of the base station
2.1.2 Charge Batteries Up to four batteries can be charged in the battery charger at the same time. The battery status lights next to each charging p
2.2 Basic Base Station Setup This section describes setup and equipment connections for an individual base station. Connect the two enclosed ante
2.3 COMMUNICATOR® Setup and Registration 2.3 COMMUNICATORThe first time you operate the DX210 system, you must register each Communicator (Belt Pac
2.3.2 Register COMMUNICATOR®s The Communicator must be within 6 feet (1.83 meters) of the base station to enable registration. 1. Be sure each Commu
If you try to register more than 15 Communicators: An F will appear on the STATUS display on the base station and you will hear “Registration fail
2.4 Interfacing with 2-Wire or 4-Wire Intercoms 40 41 42 43 Base station rear panel 2-Wire Intercom Interfac
IC1 and IC2 Intercom Controls and Indicator Lights: The IC1 portion of this area of the panel is for Intercom Channel 1, and the IC2 portion i
The AUXILIARY SELECT button (#25) is used to select IC1 or IC2 or both as the destination for AUX IN audio. The IC1 and/or IC2 INPUT ASSIGN lights
3 System Operation This chapter describes how to operate the Base Station and COMMUNICATOR® (Belt Pack or All-In-One Headset). 3.1 Base Station O
3.2 COMMUNICATOR® Operation Belt Pack control buttons have a snap action. They will activate wpressed firmly. Use your fingertips, not your fingernai
3.2.5 Adjusting Microphone Gain Some users talk louder/softer than others. To allow for this, microphone gain adjustment is provided. To increase
4 Troubleshooting Red light on base station power switch does not come on. Be sure the power cords are properly connected to base station, power
5 Technical Data 5.1 BS210 Base Station Specifications GENERAL Channels: 2 audio channels Frequency Range: 2400 – 2483.5 MHz Frequency Response:
5.2 BP210 Belt Pack Specifications GENERAL Channels: 2 audio channels Frequency Range: 2400 MHz – 2483.5 MHz Antenna: Internal, horizontal/vert
5.3 WH210 All-In-One Headset Specifications GENERAL Channels: 2 audio channels Frequency Range: 2400 MHz – 2483.5 MHz Antenna: Internal Freque
Appendix A: COMMUNICATOR® Indicator Light Functions BP210 Belt Pack Indicator Lights: BP210 Condition IC1 Indicator Light IC2 Indicator Light IC
Appendix B: Multiple Base Station Daisy-Chaining Two or more DX210 base stations can be “daisy-chained” together with cables connected to the 2-W co
Appendix C: Jumper Settings The base station has internal jumpers that are used to set ISO broadcast restrict, power detect by-pass, and 2-wire cha
Appendix D: Multiple Base Station Registration For multiple base stations to operate in close proximity without interference, they must all be prop
Copyright © 2011 Clear-Com, LLC, an HM Electronics, Inc. company. All rights reserved. Clear-Com, the Clear-Com logo and Clear-Com Concert are tradem
Repeat these steps for each remaining secondary base station. Use a different number for each. Only the primary base station and the secondary b
Appendix E: Interference Avoidance through Spectrum Friendly Interference, which may be heard in a headset as popping sounds, may occur whenever ot
Spectrum Friendly All DX Series wireless intercom systems now feature Spectrum Friendly™ technology for interference-free operation in the increasing
27 Clear-Com HME DX210 System Guide Appendix F: Audio Routing Diagram
有毒有害物质或元素表Table of Toxic and Hazardous Substances 部件名称 Names of Parts 有毒有害物质或元素 Toxic and Hazardous Substances or Elements 铅 Pb 镉 Cd 汞 Hg 六
有毒有害物质或元素表 Table of Toxic and Hazardous Substances 部件名称 Names of Parts 有毒有害物质或元素 Toxic and Hazardous Substances or Elements 铅 Pb 镉 Cd 汞 Hg 六价铬
表的有毒有害物质 Table of Toxic and Hazardous Substances 部件名称 Names of Parts 有毒有害物质或元素 Toxic and Hazardous Substances or Elements 铅 Pb 镉 Cd 汞 Hg 六价铬
FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions :(1) This device may not cause
Hereby, Clear-Com, LLC, an HM Electronics, Inc, company, declares that the DX210 is in compliance with the essential requirements and other re
Contents1 System Overview ...
1 System Overview The Clear-Com® HME DX210 is a 2-channel Digital Wireless Intercom System that supports up to 15 COMMUNICATOR®s per base station,
1.2 Base Station Front Panel 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 24 25 26 27 28 29 30 16 17 18 19 20 21 22 23
1.4 Belt Pack – BP210 3 4 5 2 1 6789 101. Headset cable connector 2. Power/mode lights 3. IC2 (Intercom 2
Comments to this Manuals