Clear-Com HME DX210 Operations Instructions download pdf (Page 11)

2.1.2 Charge Batteries

Up to four batteries can be charged in the battery charger at the same time. The battery status lights

next to each charging port are explained below. Up to six fully charged batteries can be stored in the

battery storage ports.

 Insert a battery in each of four charging ports until it clicks in place.

 A yellow light next to each charging port stays on while the port is empty.

When a battery is in a charging port, a flashing yellow light next to it indicates CHARGE PENDING,

which means the battery is too hot. Adjust the room temperature or move the charger to a cooler area.

When a battery is in a charging port, a yellow light on steady next to it means CHARGE FAILED.

If this happens, follow the instructions on the side of battery charger.

 A red CHARGING light next to a battery port stays on while a battery in the port is charging.

 s on when a battery in the port is fully charged. A green READY light next to a battery port goe

 Store fully charged batteries in storage ports.

ore than three weeks, the yellow indicator may light up. In this case, it does not indicate

a faulty battery.

NOTE: Batteries should not be left in charge ports after being fully charged. If a battery is left in a

charge port for m

Clear-Com HME DX210 System Guide

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

No comments

Clear-Com HME DX210 Operations Instructions Page 11