Clear-com RM-702 User Manual download pdf (Page 20)

RM-702 TWO-CHANNEL REMOTE STATION

2-8

You can change this option so that a talk signal, rather than a call sig-

nal, interrupts the program audio on channel B. You do this by re-set-

ting an internal jumper. See the next section, “Re-Setting Program

Interrupt Options,” for instructions.

The RM-702 is shipped from the factory with all DIP switches in the off

position. To enable a function, place that DIP switch in the on position.

Figure 2-7: DIP switches

RE-SETTING PROGRAM INTERRUPT

OPTIONS

When you set one of the rear-panel program interrupt DIP switches to on for

a particular channel (A or B), any call signal activated on that channel

interupts the program audio during the call signal.

You can change this option so that activating a talk signal, rather than a call

signal, interrupts the program audio for the duration of the signal. You do this

by re-setting an internal jumper on the station’s internal circuit board.

To re-set the program interrupt option:

1. Please observe anti-static procedures. Static electricity can damage a circuit

card. Please ground yourself and tools before touching the circuit card.

2. Remove the cover of the RM-702 by removing the eight Phillips screws.

3. On the main circuit board, locate one of the following:

• For channel A: The JP5 three-pin jumper, located in the center of the

circuit board.

• For channel B: The JP6 three-pin jumper, located in the center of the

circuit board.

4. A jumper plug covers two of the three pins on each jumper. To change the

program-interrupt option on your station, do one of the following:

• For channel A: Move the jumper plug so that it covers pins 1 and 2.

This causes talk signal activation to interrupt the program audio.

Momentary Only Talk B

Call-on-Talk A

Call-on-Talk B

Interrupt Announce

Interrupt External IFB

Long Line A

Long Line B

Program Interrupt A

Program Interrupt B

Program Enable A

Program Enable B

Momentary Only Talk A

Off (Default)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Comments to this Manuals

No comments

Clear-com RM-702 User Manual Page 20

Comments to this Manuals

Related products and manuals for Accessories communication Clear-com RM-702