Clear-com ICS-2003 User Manual download pdf (Page 12)

Clear-Com Communication Systems

ICS-2003 Intercom Panel Instruction Manual

1-4

Communication-Error Indicator

If the panel should lose data communication with the matrix frame:

• It will display the message “WAITING FOR ECLIPSE

CONNECTION.”

• All of the red LEDs will flash slowly.

When data communication is restored, the panel will automatically

return to normal operation.

Speaker/Headset Level Controls

To adjust the speaker or headset volume, use the “Intercom” and

“Program” volume controls. The speaker volume can also be affected

by three software-controlled functions: Page Override, Mute Level, and

Listen Level Adjustment.

Intercom Volume

The “Intercom” volume control sets the overall level of all signals

coming from the matrix frame.

Program Volume

The “Program” volume control adjusts the volume of the signal coming

into the panel through the auxiliary input of the “Miscellaneous”

rear-panel connector.

Page Override

Page override is a special function in the panel in which the intercom

volume defaults to a preset to a value when commanded to by the

central matrix. Any fixed group can be assigned the page-override

function through the configuration program.

The configuration program determines preset value for each panel. If

the preset value is lower than the setting of the front-panel volume

control, the volume will be controlled by the front-panel control.

Mute Level

This turns down the speaker level when any talk is active at the panel.

The amount of muting (measured in dB) is set by the configuration

program for each panel. This function helps prevent possible feedback.

The maximum amount of muting is 15 dB below full volume. If the front

panel control is set below that level, then muting will have no effect.

Listen Level Adjustment

The level of any active listen path can be adjusted individually. Refer to

“Listen-Level Mode” on page 8.

Headset Connector

The headset connector provides a front-panel connection for a

headset. Plugging in a headset will initially cause the panel to switch to

headset-microphone operation and will turn the speaker off.

Unplugging the headset will cause the panel to switch to

panel-microphone operation and will turn the speaker on.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 96 97

Comments to this Manuals

No comments

Clear-com ICS-2003 User Manual Page 12

Comments to this Manuals

Related products and manuals for Accessories communication Clear-com ICS-2003