Clear-com HME DX100 User Manual download pdf (Page 13)

Multiple Base Stations

This mode of operation can be used to expand the number of users communicating through multiple HME Base

Stations operating in the same portion of the 2.4 GHz to 2.48 GHz frequency band.

Primary and Secondary Base Station Settings

One base station must be designated as “primary” and all others must be designated as “secondary”. You can have

only one primary and up to 3 secondary base stations. Secondary base stations are assigned numbers 1, 2, or 3.

• Label the base stations as “Primary,” “1,” “2” and “3.”

• Start with every base station and Beltpac/Headset power off.

Set DIP Switches

Open each secondary base station and set

DIP switch #4 to the ON position as follows.

• Using a T9 torque wrench, remove the

six screws from the front panel of each

secondary base station. Lift the front

panel carefully and set it face down.

Be careful not to pull any wires loose.

• Locate the DIP switch on the transceiver circuit board inside the front panel of each secondary base station.

Set DIP switch #4 to the ON position. Leave #s 1 and 3 in the OFF position.

• Replace the front panel and screws on the secondary base stations.

• The primary base station DIP switch #4 should be in the OFF position.

DIP switch inside

secondary

base station

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

No comments

Clear-com HME DX100 User Manual Page 13