Clear-Com Cellcom Instruction Manual download pdf (Page 33)

Clear-Com Communication Systems

CellCom V2.0 Instruction Manual

2-1

QUICK START

The following exercise demonstrates how to set up a simple

configuration of wired and wireless devices in a CellCom system. The

user should have some familiarity with how CellCom operates before

attempting this exercise. If not please read through the manual first,

and then do the exercise.

To complete the exercise the following equipment will be needed.The

goal is to establish communication between these devices:

• A CellCom system including two wireless beltpacks, an antenna, and

a basestation.

• A 4-wire audio source, such as an Eclipse matrix.

• A wired beltpack, such as a Clear-Com 501 or 601 beltpack.

Specifically, this quick-start exercise shows how to:

• Wire the CellCom basestation to a party-line beltpack, a 4-wire audio

source, and a CellCom antenna.

• Assign labels to two CellCom beltpacks.

• From the CellCom basestation, create a group containing the wired

and wireless devices.

• Initiate calls between members of the group.

Note: For a quick overview of the CellCom programming menus,

refer to Appendix 2.

CONNECTING THE BASESTATION

To connect the CellCom basestation to a party-line beltpack

1. Make sure the CellCom basestation is powered off.

2. Connect an XLR cable from the “PL CH-A” connector on the rear of

the CellCom basestation to a wired party-line beltpack, such as an

RS-601 (connection 1). See Figure 2-1 for an illustration.

Note: Externally powered party-line equipment, CellCom splitters,

and CellCom active antennas should always be connected

and powered up before powering the CellCom basestation.

To Connect the CellCom Basestation to a 4-wire matrix port

1. Connect a CAT-5 cable from the CellCom basestation’s leftmost

4-wire audio port (labeled “4-Wire/Eclipse Ports”) to an external

4-wire audio source, such as an Eclipse matrix port (connection 2).

See Figure 2-1 for an illustration (shielded CAT-5 is recommended).

This exercise demonstrates

how to set up a simple

configuration.

In this exercise establish

communication between a

group of wired and wireless

devices.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 210 211

Comments to this Manuals

No comments

Clear-Com Cellcom Instruction Manual Page 33

Comments to this Manuals

Related products and manuals for Telephones Clear-Com Cellcom