Clear-com HX System Frames User Manual Page 22
- Page / 145
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
3.3 Interface cards
You can fit 7 interface cards to the Eclipse HX-Median.
The number of different types of interface card you can fit to the matrix frame is limited by the
available port count (112 audio ports). For more information, see
4.4.3 Combining interface cards in the frame.
Interface cards slide vertically into the front of the matrix frame and connect to the backplane.
Note:
The term central matrix is used to differentiate the core hardware and software from the
connected intercom panels and interfaces. The central matrix itself consists of the matrix
hardware (in this case, the Eclipse HX-Median) and the EHX configuration software.
Tip: For detailed information about installing interface cards, see 4.4 Installing interface cards.
3.3.1 MVX-A16 analog port card
An MVX-A16 analog port card controls the operation of panels and interfaces connected to
it. Panels and interfaces connect to the port card through an RJ-45 connector (port) on the
HX-Median rear panel. Shielded category-5 cable attaches the panel or interface to the RJ-
45 connector.
The MVX-A16 analog port card sends balanced audio and RS-422 data signals to connected
audio equipment through 4-pair shielded CAT5 cable. The card connects up to 16 audio
devices (such as user panels, interfaces, or four-wire audio equipment) to the central matrix.
Each audio device connected to an analog port card communicates with all other audio
devices in the system and with the central matrix.
Intelligent linking
For intelligent linking, shielded CAT5 cable is run from a port on one Eclipse HX-Median
matrix to a port on a second Eclipse HX-Median matrix to form a trunkline connection.
3.3.2 E-FIB fiber card
E-FIB fiber interfaces connect Eclipse HX matrices together to provide a high speed, dual
redundant link to transfer audio samples and data between systems. These connections can
be configured to provide protection against the loss of a link or a node.
Each E-FIB fiber interface card set comprises:
• A front card with various status indicators.
• A rear card with two Duplex LC Terminated fiber optic connectors
(TXVRA and TXVRB).
22
Eclipse HX-Median User Guide
- Eclipse HX-Median User Guide 1
- Document Reference 2
- Legal Disclaimers 2
- Clear-Com Contacts 2
- Contents 3
- Safety symbols 10
- Mains power cord 10
- 2 Introduction 11
- 2.1 Chapters summary 12
- 2.2 Further information 13
- 3 Overview 14
- 3.2 Eclipse HX-Median 15
- 3.2.2 Power supplies 20
- 3.2.4 CPU card 21
- 3.3 Interface cards 22
- 3.3.6 LMC-64 interface card 24
- 3.4 Interface modules 25
- 3.6 User panels 26
- 4 Installing the 27
- Eclipse HX-Median 27
- Low power warning 29
- 4.3 Installing CPU cards 32
- 4.3.1 Hot patching CPU cards 33
- Figure 6: CPU card lights 34
- 4.4.4 Static sensitivity 37
- 4.4.6 Analog port numbering 37
- 4.4.7 Configuration 38
- 4.6.1 4-Pair analog 40
- 4.6.2 Single-pair digital 41
- Figure 19: Non-isolated mode 50
- 169.254.0.100 and the 55
- 0.0.0.0 (blank) address 55
- 5.4 CPU card fail-safes 56
- 169.254.000.100 60
- ACTIVE VOX 63
- 5.7.2 Main alarm light 67
- 5.7.3 Alarm reset button 68
- 5.7.5 Power supply lights 69
- 6 E-MADI64 card 73
- Important note: 75
- 6.3 MADI channels 78
- 6.3.1 MADI channel labeling 79
- 7 E-FIB fiber card 82
- Transceiver lasers 86
- System 1 System 2 88
- System 3 88
- Redundant ring 88
- Primary ring 88
- 7.4 Simplex fiber cabling 89
- Loss of a single node 90
- Loss of two nodes 90
- 7.4.3 Fault tolerance 93
- System #1 System #2 System #3 95
- System #4System #5 95
- Secondary ring 95
- 8 E-QUE E1/T1 card 96
- 8.5 T1 trunking 107
- 8.6 Trunking failover 109
- 9 IVC-32 card for IP-based 110
- 9.3.1 V-Series IP Panels 114
- 9.3.3 Concert Users 115
- 10 LMC-64 metering card 116
- 11 Maintaining the 122
- Eclipse HX-Median 122
- 11.2 Fail-Safe modes 123
- 11.3 Troubleshooting 124
- Example power supply issues 125
- CPU card Reset button 128
- CPU card Full Reset button 128
- Example data issues 128
- 11.4 System block diagram 129
- 12 Specifications 130
- 12.3 Environmental 131
- 12.7 E-MADI64 fiber cable 132
- 12.9 E-MADI64 clock sources 133
- 12.12 Fiber cable 134
- 12.13 Fiber transceiver 134
- 12.23 System programming 138
- (for EHX software) 140
- 12.26 Power supply unit 141
- 13 Glossary 142
Related products and manuals for Accessories communication Clear-com HX System Frames
(186 pages)© 2020, manymanuals.com. All rights reserved. | 4.503 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals