Clear-com HX System Frames User Manual download pdf (Page 251)

4) Activate a talk for the telephone

5) Activate the speed dial (make the call).

Alternatively:

1) Set-up telephone and speed dial as above.

2) Switch matrices

3) Program the telephone interface onto any required panels

4) Double click the talk label to the telephone interface

5) Select controls and click on the speed dial control

6) Add to the stacked key area.

7) Download to the matrix

Activating the talk to the telephone operate the speed dial and the call is made

10.7.3 Off hook and off hook tally

If a talk route is made to that telephone port from either a local or a remote system the

telephone is automatically placed off-hook.

Note: The telephone port must be set to Auto-Signal.

The off hook tally state of a telephone port is broadcast to all the systems in a linked set.

To check if the telephone port has been configured as an off hook tally, see the entity

table.

10.7.4 Auto listen

In Eclipse HX v7.5, you can set Auto Listen for ports on both the local matrix and remote

matrices.

If a remote port on a matrix has Auto Listen set, any talk path made to it from anywhere in

the system has a return listen route made.

10.8 Remote controls

Controls from one system are made available for use in another system.

To configure remote controls

1) Create the required controls on a local system

2) Select Save Linked Configurations

251

Eclipse EHX Software User Guide

1 2 ... 246 247 248 249 250 251 252 253 254 255 256 ... 289 290

No comments

Clear-com HX System Frames User Manual Page 251