Clear-com BS850 (Last time buy) User Manual download pdf (Page 14)

BASE STATION OPERATION

Uses of Front Panel Controls, Indicators and Connectors

1. Power Switch

Press the upper part of the switch to turn the power on. A red light on the switch will be lit when the base

station power is on. Press the lower part of the switch to turn the power off. The red light will go off.

2. Beltpac Configuration Connector

After Beltpac configuration settings have been made in the base station, plug one end of the enclosed RJ10

interconnect cable into this connector, and plug the other end into the RMT receptacle on the bottom of a

Beltpac to upload the settings into the Beltpac. Repeat this to upload settings for each Beltpac to be used.

CAUTION: Be sure not to turn the Beltpac power off and on again while it is connected to the base

station. If this does happen, unplug the cable and cycle the Beltpac power again.

3. Wired Status Indicator Lights

CH1 and CH2 lights:

If a 4-wire intercom channel is enabled, the respective CH1/CH2 light will blink when the PRO850 is

sending audio on that intercom line.

If a 2-wire interface channel is enabled, the respective CH1/CH2 light will be on steady when the user

is not talking. When the user is talking, the light will be on steady and blinking off.

AUX light:

The auxiliary light indicates use of the ISO+ mode. When ISO+ is on, the AUX light will be on

steady. When someone is talking on the ISO channel, the light will be on steady and blinking off.

4-5. Receiver Status Indicators and Buttons

RECEIVER STATUS lights 1 – 4:

Steady red if the respective receiver squelch is turned down, or if it is receiving a signal (squelch is open).

Blinking amber when the respective receiver is receiving status update from a Beltpac.

Steady green when the Beltpac user is talking through the receiver.

Blinking red or green if the Beltpac being received has a low battery condition.

RECEIVER QUICK MENU buttons 1 – 4:

When pressed, squelch and audio controls for the respective receiver are provided immediately on the

display screen.

11-15. Local Headset Connector and Controls

Plug your local headset connector into the receptacle at the right end of the PRO850 front panel.

Use the SELECT button to choose communication channels CH1, CH2, CH1 and CH2 together, or ISO.

The respective indicator light above the button will remain lit for the selection you make.

Press and release the TALK button quickly to “latch on” for open communication. Press and release the

button again quickly to “latch off.”

Press and hold the TALK button for more than one second for momentary communication. In this mode,

the selected channel will remain open only as long as you are pressing the TALK button.

SECTION 3. PRO850 OPERATION

1 2 3 4-5

11-15

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

No comments

Clear-com BS850 (Last time buy) User Manual Page 14