Clear-com BS850 (Last time buy) User Manual download pdf (Page 24)

Beltpac Receiver Frequency:

Select the desired Beltpac and the receiver

frequency for that Beltpac’s operation (P1-4, S1-4,

T1-4 or U1-16. If U1-16 is selected, use the

control knob and the up and down arrow buttons to

select the desired frequency, in 25kHz increments.

NOTE: When only one receiver is present, it will

switch between the two frequencies as needed.

When two receivers are present, the primary

receiver is RX1 and the second receiver is RX2.

Normally, RX1 is for intercom CH1. RX2 is for

intercom CH2, unless base station TX2 is off or in

IFB mode. In that case, both intercom channels go

through base TX1 and thus Beltpac RX1. Normally,

Beltpac RX1 is the same as base station TX1, and

Beltpac RX2 is the same as base station TX2.

Beltpac Receiver Squelch Level:

Select the Beltpac and receiver, then use the

control knob to adjust its squelch level.

NOTE: RX2 squelch adjustment is reserved for a

second receiver, when a Beltpac has two receivers.

BPCN is the Beltpac that is plugged into the base

station, therefore adjustments to its squelch level

are effective immediately.

Beltpac Buttons A and B Setup:

Select the Beltpac and the Mode (Off, Momentary

or Lock) for Buttons A and B on each Beltpac.

CH1 = Talk, Channel 1

CH2 = Talk, Channel 2

Both = Talk, both Channels 1 and 2

Curr = Talk, Current Channel selected

ISO1 = Talk, to Beltpacs receiving only TX1

ISO2 = Talk, to Beltpacs receiving only TX2

ISO = Talk, to Beltpacs receiving both TX1 and TX2

Page = Talk, Page (stage announce)

Aux = Talk, Auxiliary Out

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 49 50

No comments

Clear-com BS850 (Last time buy) User Manual Page 24