Clear-com HME DX200 User Manual

HM ELECTRONICS, INC. 14110 Stowe Drive, Poway, CA 92064 USA • Phone: 1-800-848-4468 Fax: (858) 552-0172 HME# 400G612 Rev B 7/3/08 WS200 W

2Power Setup AC Power Operation If using the WS200 with AC power ⎯ • Plug the connector at the end of the power supply cord into the 12-14 VDC p

3WS200 Registration The first time you operate the WS200, you must register it for use with a specific DX100 or DX200 Base Station. The base station

4MB100 Base StationCLR REGbutton REGISTRATIONSTATUS display RESETbutton If registration failed: • A voice message will say “Power on, Speaker, Versi

5OPERATION Headset Connection If you are using a headset with the WS200, plug it into the headset connector. When using a headset, if the red li

6Routine Operation Power On/Off • To turn WS200 power on, press and release the POWER button. — Red lights will go on over the POWER, ISO and IC

7Headset Microphone Gain Adjustment Some users speak louder or softer than others. The headset microphone gain adjustment helps to compensate for t

8EQUIPMENT SPECIFICATIONS Frequency Range: 2400 – 2483.5 MHz Frequency Response: 200 Hz to 3.5 kHz Power Requirements: Six AA batteries (NiMH op

9 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful