Clear-Com WBS-670 Operations Instructions download pdf (Page 11)

WTR-670 Beltpack

Controls and Connections - Top Panel

Figure 4

WTR-670 Top Panel

1. On/Off & Volume Control – Turns the beltpack power

on and controls headset volume.

2. Bat/Overmod Light – Light will flash once when unit is

turned on if the battery is good. If the light stays on, bat-

tery is low. If the light does not flash, battery is dead. A

normal microphone gain setting will cause the LED to

flash at the beginning of most words at normal speech

levels. If the gain is too high, the LED will be red during

the complete word at normal speech levels.

3. Talk Light – LED is on when the talk button is active.

4. Talk button – Press to enable the audio path from the lo-

cal headset microphone. The “TALK” LED, #3, will turn

red when enabled. A quick press and release latches the

talk function, unless latching has been disabled in soft-

ware. Holding the button for over ½ a second will cause

the audio path to be enabled only for as long as the button

is held. If the talk function is latched on, pressing the talk

button again will turn it off.

3-1

Bat/OM Talk

Vol

Off

TALK

Section

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 61 62

No comments

Clear-Com WBS-670 Operations Instructions Page 11